C
HAPTER
13
| Security Measures
AAA (Authentication, Authorization and Accounting)
– 308 –
n
Exec – Administrative accounting for local console, Telnet, or SSH
connections.
u Privilege Level – The CLI privilege levels (0-15). This parameter only
applies to Command accounting.
u Method Name – Specifies an accounting method for service requests.
The “default” methods are used for a requested service if no other
methods have been defined. (Range: 1-64 characters)
Note that the method name is only used to describe the accounting
method configured on the specified RADIUS or TACACS+ servers. No
information is sent to the servers about the method to use.
u Accounting Notice – Records user activity from log-in to log-off point.
u Server Group Name - Specifies the accounting server group.
(Range: 1-64 characters)
The group names “radius” and “tacacs+” specifies all configured
RADIUS and TACACS+ hosts (see "Configuring Local/Remote Logon
Authentication" on page 301). Any other group name refers to a server
group configured on the Security > AAA > Server (Configure Group)
page.
Configure Service
u Accounting Type – Specifies the service as 802.1X, Command or Exec
as described in the preceding section.
u 802.1X
n
Method Name – Specifies a user defined accounting method to
apply to an interface. This method must be defined in the Configure
Method page. (Range: 1-64 characters)
u Command
n
Privilege Level – The CLI privilege levels (0-15).
n
Console Method Name – Specifies a user-defined method name
to apply to commands entered at the specified CLI privilege level
through the console interface.
n
VTY Method Name – Specifies a user-defined method name to
apply to commands entered at the specified CLI privilege level
through Telnet.
u Exec
n
Console Method Name – Specifies a user defined method name to
apply to console connections.
n
VTY Method Name – Specifies a user defined method name to
apply to Telnet connections.
To Next Page