Digisol DG-GS4528SE - Page 48

F IGURES
– 49 –
Figure 284: Sub-ring without Virtual Channel 488
Figure 285: Creating an ERPS Ring 492
Figure 286: Creating an ERPS Ring 493
Figure 287: Showing Configured ERPS Rings 493
Figure 288: Blocking an ERPS Ring Port 498
Figure 289: Single CFM Maintenance Domain 499
Figure 290: Multiple CFM Maintenance Domains 500
Figure 291: Configuring Global Settings for CFM 504
Figure 292: Configuring Interfaces for CFM 505
Figure 293: Configuring Maintenance Domains 509
Figure 294: Showing Maintenance Domains 509
Figure 295: Configuring Detailed Settings for Maintenance Domains 510
Figure 296: Creating Maintenance Associations 513
Figure 297: Showing Maintenance Associations 514
Figure 298: Configuring Detailed Settings for Maintenance Associations 514
Figure 299: Configuring Maintenance End Points 516
Figure 300: Showing Maintenance End Points 516
Figure 301: Configuring Remote Maintenance End Points 518
Figure 302: Showing Remote Maintenance End Points 518
Figure 303: Transmitting Link Trace Messages 520
Figure 304: Transmitting Loopback Messages 521
Figure 305: Transmitting Delay-Measure Messages 523
Figure 306: Showing Information on Local MEPs 524
Figure 307: Showing Detailed Information on Local MEPs 526
Figure 308: Showing Information on Local MIPs 527
Figure 309: Showing Information on Remote MEPs 528
Figure 310: Showing Detailed Information on Remote MEPs 530
Figure 311: Showing the Link Trace Cache 532
Figure 312: Showing Settings for the Fault Notification Generator 533
Figure 313: Showing Continuity Check Errors 534
Figure 314: Enabling OAM for Local Ports 537
Figure 315: Displaying Statistics for OAM Messages 538
Figure 316: Displaying the OAM Event Log 539
Figure 317: Displaying Status of Remote Interfaces 540
Figure 318: Running a Remote Loop Back Test 542
Figure 319: Displaying the Results of Remote Loop Back Testing 543