C
HAPTER
15
| Multicast Filtering
Multicast VLAN Registration for IPv4
– 582 –
Figure 347: Configuring Interface Settings for MVR
ASSIGNING STATIC
MVR MULTICAST
GROUPS TO
INTERFACES
Use the Multicast > MVR (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI REFERENCES
u "mvr vlan group" on page 1225
COMMAND USAGE
u Multicast groups can be statically assigned to a receiver port using this
configuration page.
u The IP address range from 224.0.0.0 to 239.255.255.255 is used for
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
u Only IGMP version 2 or 3 hosts can issue multicast join or leave
messages. If MVR must be configured for an IGMP version 1 host, the
multicast groups must be statically assigned.
u The MVR VLAN cannot be specified as the receiver VLAN for static
bindings.
PARAMETERS
These parameters are displayed:
u Domain ID – An independent multicast domain. (Range: 1-5)
u Interface – Port or trunk identifier.
u VLAN – VLAN identifier. (Range: 1-4093)
u Group IP Address – Defines a multicast service sent to the selected
port. Multicast groups must be assigned from the MVR group range
configured on the Configure General page.
To Next Page