C
ONTENTS
– 7 –
Performing Cable Diagnostics 160
Trunk Configuration 162
Configuring a Static Trunk 163
Configuring a Dynamic Trunk 166
Displaying LACP Port Counters 172
Displaying LACP Settings and Status for the Local Side 173
Displaying LACP Settings and Status for the Remote Side 175
Saving Power 176
Sampling Traffic Flows 178
Configuring sFlow Global Settings 179
Configuring sFlow Interface Settings 179
Traffic Segmentation 181
Enabling Traffic Segmentation 181
Configuring Uplink and Downlink Ports 183
VLAN Trunking 185
6VLAN CONFIGURATION 187
IEEE 802.1Q VLANs 187
Configuring VLAN Groups 190
Adding Static Members to VLANs 193
Configuring Dynamic VLAN Registration 197
IEEE 802.1Q Tunneling 200
Enabling QinQ Tunneling on the Switch 204
Creating CVLAN to SPVLAN Mapping Entries 205
Adding an Interface to a QinQ Tunnel 207
Protocol VLANs 209
Configuring Protocol VLAN Groups 209
Mapping Protocol Groups to Interfaces 211
Configuring IP Subnet VLANs 213
Configuring MAC-based VLANs 215
Configuring VLAN Mirroring 217
Configuring VLAN Translation 218
7ADDRESS TABLE SETTINGS 221
Setting Static Addresses 221
Changing the Aging Time 223
Displaying the Dynamic Address Table 224
Clearing the Dynamic Address Table 225
To Next Page
Loading...
