C
HAPTER
17
| IP Services
Domain Name Service
– 630 –
CONFIGURING A LIST
OF
NAME SERVERS
Use the IP Service > DNS - General (Add Name Server) page to configure a
list of name servers to be tried in sequential order.
CLI REFERENCES
u "ip name-server" on page 1333
u "show dns" on page 1335
COMMAND USAGE
u To enable DNS service on this switch, configure one or more name
servers, and enable domain lookup status (see "Configuring General
DNS Service Parameters" on page 627).
u When more than one name server is specified, the servers are queried
in the specified sequence until a response is received, or the end of the
list is reached with no response.
u If all name servers are deleted, DNS will automatically be disabled. This
is done by disabling the domain lookup status.
PARAMETERS
These parameters are displayed:
Name Server IP Address – Specifies the IPv4 or IPv6 address of a
domain name server to use for name-to-address resolution. Up to six IP
addresses can be added to the name server list.
WEB INTERFACE
To create a list name servers:
1. Click IP Service, DNS.
2. Select Add Name Server from the Action list.
3. Enter one name server at a time.
4. Click Apply.
Figure 383: Configuring a List of Name Servers for DNS
To show the list name servers:
1. Click IP Service, DNS.
2. Select Show Name Servers from the Action list.
To Next Page