Digisol DG-GS4528SE - Page 796

C HAPTER 25 | Flow Sampling Commands
– 808 –
sflow timeout This command configures the length of time samples are sent to the
Collector before resetting all sFlow port parameters. Use the no form to
restore the default time out.
SYNTAX
sflow timeout seconds
no sflow timeout
seconds - The length of time the sFlow process continuously sends
samples to the Collector before resetting all sFlow port parameters.
(Range: 0-10000000 seconds, where 0 indicates no time out)
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
The sFlow agent sends sample data to an sFlow collector until the timeout
set by this command expires. The sFlow agent then resets the sampling
interval, the receiver’s name, address and UDP port, the time out,
maximum header size, and maximum datagram size.
EXAMPLE
This example sets the time out to 1000 seconds.
Console(config)#interface ethernet 1/9
Console(config-if)#sflow timeout 10000
Console(config-if)#
show sflow This command shows the global and interface settings for the sFlow
process.
SYNTAX
show sflow interface [interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28/52)