Digisol DG-GS4528SE - Page 935

C HAPTER 28 | Access Control Lists
IPv6 ACLs
– 949 –
ipv6 access-group This command binds a port to an IPv6 ACL. Use the no form to remove the
port.
SYNTAX
ipv6 access-group acl-name {in | out}
[time-range time-range-name] [counter]
no ipv6 access-group acl-name {in
| out}
acl-name – Name of the ACL. (Maximum length: 16 characters)
in – Indicates that this list applies to ingress packets.
out – Indicates that this list applies to egress packets.
time-range-name - Name of the time range.
(Range: 1-16 characters)
counter – Enables counter for ACL statistics.
DEFAULT SETTING
None
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
If a port is already bound to an ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
EXAMPLE
Console(config)#interface ethernet 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#
RELATED COMMANDS
show ipv6 access-list (948)
Time Range (764)
show ipv6 access-
group
This command shows the ports assigned to IPv6 ACLs.
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show ipv6 access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#