Doremi ShowVault - Page 112

• Plug the power cables for the projector into a reliable power source.
• Power on the projector and wait for the IMB board to properly boot (approximately two
minutes).
• Power on the ShowVault by pressing the power button.
Figure 119: Power Button on the ShowVault
• Once the ShowVault is properly booted up go to "Diagnostic Tool" by clicking "Menu →
Doremi Apps. → Diagnostic Tool".
• Confirm that the following parameters are present: Serial Number, Firmware Version,
and SM Version.
Figure 120: Diagnostic Tool Menu
• Run the "Device Manager" program to set up the Christie Series 2 Projector.
_____________________________________________________________________________________
SHV.OM.001293.DRM Page 112 Version 1.3
Doremi Cinema LLC Confidential