Dover Markem Imaje 9040 - Faults Specific to 9040 Contrast Printers (cont.)

Alarms and faults
A36951-C.doc
182/236
10- Shutdown fault 13 10a- Activate following electrovalves:
- A/P.
- Viscometer
10b- Press the
key to clear the fault. Contact
Markem-Imaje Technical Assistance if the fault
persists.
11- Shutdown fault 15 or 19 11a- Activate all electrovalves.
11b- Press the
key to clear the fault. Contact
Markem-Imaje Technical Assistance if the fault
persists.
12- Viscometer fault 08 12a- Activate following electrovalves:
- Viscometer
- A/P.
12b- Press the
key to clear the fault. Contact
Markem-Imaje Technical Assistance if the fault
persists.
NOTE (Faults 16 to 23)
The electrovalves can be activated in "Standby phase" after
"Sub-phase 21" is displayed. Refer to section XX of this
manual for ELV activation procedures.