Editing a message
A36951-C.doc
64/236
ʄ Printing repetition
This parameter is used in object set-off mode (Set off field set to OBJECT) to repeat
printing at a pre-set number of times regardless of the length of the object be marked.
Enter a value between 0 and 255.
Example:
Printing repetition: 1 means that a single message is printed and is not repeated.
Printing repetition: 2 means that two messages are printed for every DTOP received.
ʄ Print speed
If the product travels at a constant speed (Speed measurement field set to CONSTANT
SPEED), enter the speed value in millimeters per second.
ʄ Tacho division
This field is only applicable if tacho mode is selected (Speed measurement field set to
TACHO)
Enter a number between 1 and 255. Increase or decrease this value according to adjust
the printed character width obtained when printing.
ʄ Algo
Choose an algorithm or allow the printer to select the most appropriate one for the
programmed print speed automatically (AUTO).
The printer will suggest a selection of suitable fonts in the
function (Message
editing/Font/Select font) on the basis of the setting made.
The message editing fonts and available print lines are determined by the algorithm
chosen.
To Next Page
Loading...
