Editing a message
A36951-C.doc
65/236
REMINDER New algorithm or print speed settings cannot be made on
messages that have already been created.
The content of the message has to be deleted first if you want
to change these parameter settings.
ʄ Forward margin
Enter a forward margin value (in millimeters).
This parameter represents the space between the point where the object is detected and
the point where the message starts to be printed if the printed message starts from the first
character.
ʄ Return margin
Enter a return margin value (in millimeters).
This parameter represents the space between the point where the object is detected and
the point where the message starts to be printed if the printed message starts from the
final character.
ʄ Interval
Enter an interval value (in millimeters).
This parameter represents the space between two print operations in repetitive set-off
mode (Set off field set to REPETITIVE) or if "Printing repetition" is active.
ʄ Top filter
Enter a time value (in ȝs).
This parameter is the minimum time value that the object detection signal has to reach to
be taken into account by the printer. You can increase this time value if you have noticed
that messages have been printed at the wrong time.
ʄ Set off
To determine how printing is to be set off.
Options:
Ƒ MANUAL OBJECT or MANUAL AUTO: If you want to perform manual print tests.
. MANUAL OBJECT: Printing is triggered when you press the spacebar on your
keyboard. Printing is performed every time the spacebar is pressed.
. MANUAL AUTO: Printing is triggered when you press the spacebar and is repeated
until you press the spacebar again.
This means that you can print out the same message automatically several times
between each time you press the spacebar manually.
To Next Page
Loading...
