Draytek VigorAP 906 User Manual

100
III-1-9 Management
This page allows you to specify the port number for HTTP and HTTPS servers.
Available parameters are explained as follows:
Item Description
Device Name The default setting is VigorAP 906. Change the name if required.
Access Control Check the box(es) listed in this area to enable the various servers.
Port Setup HTTP port/HTTPS port -Specify user-defined port numbers for the
HTTP and HTTPS servers.
TLS Encryption Setup TLSv1.2/ TLSv1.1 or above/TLSv1.0 or above – Check the box to
enable TLS encryption protocols.
For improved security, the HTTPS servers that are built into the router
have been upgraded to TLS 1.x protocol.
Panel Control Disable LED - The LEDs blink always since VigorAP is powered on.
Some people might not like that. Therefore the function of LED is
allowed to be disabled to make people feeling comfortable and
undisturbed. After checking it, all the LEDs on VigorAP will light off
immediately after clicking OK.
Enable Default Configuration Wizard – The default setting is
enabled. When it is enabled, you will be guided into Quick Start
Wizard whenever clicking the DrayTek logo on the top of the web
user interface.
Such function will be disabled if you have configured Operation Mode,

Draytek VigorAP 906 Specifications

General

2.4 GHz	Yes
MIMO type	Multi User MIMO
Number of users	254 user(s)
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	2402 Mbit/s
Maximum data transfer rate (2.4 GHz)	574 Mbit/s
Placement	Ceiling, Table, Wall
Product color	White
Security algorithms	WEP, WPA, WPA2, WPA3, WPS
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
WAN connection	Ethernet (RJ-45)
USB 2.0 ports quantity	-
Ethernet LAN (RJ-45) ports	5
Antenna type	External
Antenna direction type	Omni-directional
Antenna gain level (max)	2.5 dBi
Input current	0.4 A
Output current	1.5 A
AC input voltage	48 - 56 V
DC voltage range	12 V
Power consumption (max)	17.3 W
Sustainability certificates	CE