Draytek VigorAP 906 User Manual

50
II-3-11 Roaming
The network signal for a single wireless access point might be limited by its coverage range.
Therefore, if you want to expand the wireless network in a large exhibition with a quick method, you
can install multiple access points by enabling the Roaming feature for each AP to reach the purpose
of expanding wireless signals seamlessly.
These access points connecting for each other shall be verified by pre-authentication. This page
allows you to enable the roaming feature and the pre-authentication.
Available settings are explained as follows:
Item Description
AP-assisted Client
Roaming Parameters
When the link rate of the wireless station is too low or the signal
received by the wireless station is too worse, VigorAP 906 will
automatically detect (based on the link rate and RSSI requirement)
and cut off the network connection for that wireless station to assist it
to connect another Wireless AP to get better signal.
Minimum Basic Rate – Check the box to use the drop-down list to
specify a basic rate (Mbps). When the link rate of the wireless station
is below such a value, VigorAP 906 will terminate the network
connection for that wireless station.
Disable RSSI Requirement - If it is selected, VigorAP will not
terminate the network connection based on RSSI.
Strictly Minimum RSSI - VigorAP uses RSSI (received signal strength
indicator) to decide to terminate the network connection of the
wireless station. When the signal strength is below the value (dBm)
set here, VigorAP 906 will terminate the network connection for that
wireless station.
Minimum RSSI - When the signal strength of the wireless station is

Draytek VigorAP 906 Specifications

General

2.4 GHz	Yes
MIMO type	Multi User MIMO
Number of users	254 user(s)
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	2402 Mbit/s
Maximum data transfer rate (2.4 GHz)	574 Mbit/s
Placement	Ceiling, Table, Wall
Product color	White
Security algorithms	WEP, WPA, WPA2, WPA3, WPS
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %
WAN connection	Ethernet (RJ-45)
USB 2.0 ports quantity	-
Ethernet LAN (RJ-45) ports	5
Antenna type	External
Antenna direction type	Omni-directional
Antenna gain level (max)	2.5 dBi
Input current	0.4 A
Output current	1.5 A
AC input voltage	48 - 56 V
DC voltage range	12 V
Power consumption (max)	17.3 W
Sustainability certificates	CE