Draytek VigorAP 906 - I-2-3 Wireless Connection

6
I-2-3 Wireless Connection
VigorAP 906 can access the Internet via an ADSL modem, router, or switch/hub in your network
through a wireless connection.
1. Connect the A/C power adapter to the wall socket, and then connect it to the PWR connector
of the access point.
2. Power on VigorAP 906.
3. Check all LEDs on the front panel. ACT LED should be steadily on.
4. Connect VigorAP 906 to the ADSL modem or router via a wireless network.
(For detailed information on LED status, please refer to section I-1-1.)