73
iPad connects to hop3 Node : 26Mbps (Uplink RSSI : hop3 -62dBm / hop2 -68dBm / hop1
-55dBm)
It is not suggested to use a wireless Mesh Node with Ethernet cable connected to a Mesh Root.
If resetting a Mesh Root,
- All "connected" Mesh Nodes will be informed to reset.
- Group List and Group Key will be reset, too.
- For those Mesh Nodes unable to reset, reset them manually. Reset the Group List by web
or factory default.
If resetting a Mesh Node,
- Group List and Group Key will be cleared.
- Link Status will become "New".
Mesh network status also can be viewed and checked through the dashboard by clicking MESH
NETWORK.
If Mesh Search / Apply / Discover is worked too fast or is done with the empty result, your
request may be rejected. Please try again.
Troubleshooting:
- Check the firmware version. Please make sure all APs within the mesh group are in the
newest firmware version.
- Check the OP (operation) Mode. Make sure the new Mesh Node doesn't accidentally get
DHCP IP and becomes AP mode.
- Check the country code and channels. For example, it is impossible for connecting a
VigorAP 906 Mesh Root with 5G channel 36 to VigorAP920R Wireless Mesh Node in EU
country code.
- Check the channel load. Make sure it is not over 70%.
To Next Page
Loading...
