Copyright 2008 Baker Hughes Company.
vi | PACE5000/6000 Instruction Manual–English
4. Maintenance 35
4.1 Introduction 35
4.2 Visual Inspection 35
4.3 Cleaning 35
4.4 Test 35
4.5 Software Update 35
4.6 Replacement Parts 37
4.6.1 Fuse Replacement 37
4.6.2 Pressure Control Module Filters 38
4.6.3 Pressure Control Module Replacement 39
5. Testing and Fault Finding 41
5.1 Introduction 41
5.2 Standard Serviceability Test 41
5.3 Fault Finding 42
5.4 Approved Service Agents 42
6. Reference 43
6.1 Installation Notes 43
6.1.1 Gas Supply 43
6.1.2 Supply Conditioning Equipment 43
6.1.3 Maximum Working Pressure 43
6.1.4 Supply Contamination 43
6.1.5 Systems without a Negative Supply 44
6.1.6 General 44
6.1.7 Operating Near Atmospheric Pressure or Below 44
6.1.8 Vacuum Pump 44
6.2 Operational Requirements 44
6.2.1 Negative or Vacuum Supply 44
6.2.2 Oil Contamination 45
6.2.3 Pump Performance 45
6.2.4 Venting 45
6.2.5 Vent 45
6.2.6 Zero 45
6.2.7 Output Port 45
6.2.8 Reference Port 45
6.3 Measure Setup 46
6.3.1 Pressure Zero 46
6.3.2 Process 46
6.3.3 Task 46
6.3.4 Units 46
6.3.5 Global Setup 46
6.3.6 Setup Zero 46
6.4 Control Setup 47
6.4.1 Vent 47
6.4.2 Nudge 47
6.4.3 Set-point Limits 47
6.4.4 Slew Rate 47
6.4.5 Control Mode 47
6.4.6 Active Control 47
6.4.7 Passive Control 47