Duplo DP-S550 User Manual

108
x Scanner Section
chap.3
Reinstallation
1. Remove the document cover.
2. Remove the scanner outer cover(Front,Rear).
3. Remove the control panel.
4. Remove the rear cover.
\See page 100
\See page 101
\See page 99
\See page 98
5. Remove the screw indicated, and remove the
stopper.
6. Remove the screw indicated, and remove the angle.
7. Press the scanner switch to slide the scanner
unit.
8. Remove 6 screws and then remove the scanner
unit by sliding it to the paper ejection side.
(8) Removal of Scanner unit
Notch
R8S03032
R8S03031
Rail
Slide stopper
Screws
Screws
Rail
Notch
Screw
hole
Scanner
unit
Screw hole
Screw hole
Screw hole
Screw
hole
R8S03031a
Screw Screw
Scanner switch
Angle Stopper
Stopper
Angle
Do not place the scanner unit
directly on the floor.
IMPORTANT :
When closing the scanner unit, the
rail holes align with the frame holes.
NOTE :
1. Place the scanner unit on the notches from the
paper ejection side.
2. Close the scanner unit.
3. Slide the scanner unit and attach the 6 screws.
4. Set the stopper and attach the screw.
5. Set the angle and attach the screw.
6. Close the scanner unit.
Screw
holes
Screw
hole
Screw
holes

Duplo DP-S550 Specifications

General

Brand	Duplo
Model	DP-S550
Category	Disc Duplicator
Language	English