134
Chapter 4 Standards / Adjustment
z Scanner Section.........................................................136
(1) Attaching the Rear Wire ......................................136
(2) Attaching the Front Wire.....................................137
x Platemaking / Master Feed / Ejection Section........138
Platemaking /
Master Feed Section
......................138
(1) Adjusting the Timing Belt Tension......................138
(2) Position Adjustment of Thermal Head
Up/Down Motor....................................................138
Master Ejection Section .........................................139
(1) Attaching the Spring............................................139
(2) Adjusting the Timing Belt Tension......................141
Master Clamp opening/Closing Section ..............142
(1) Adjusting the Timing Belt Tension......................142
(2) Positioning the Master Clamp
Opening / Closing Levers.....................................142
(3) Adjusting the B / C Modes ...................................143
c Paper Feed Section ...................................................145
(1) Adjusting the Paper Separator
Unit Clearance.....................................................145
(2) Adjusting the Elevator Top Limit Sensor............145
(3) Adjusting the Elevator Lower Limit Switch.......146
(4) Adjusting the Double Feed Detection Sensors....147
(5) Adjusting the G Roll Escape
Amount / Timing...................................................148
(6) Adjusting the Vertical Registration Sensors.......149
v Drum Driving Section................................................150
(1) Adjusting the Drum Stop Position.......................150
(2) Adjusting the Master Attach Position
..................
151
To Next Page
Loading...
Need help?
General
