202
c HELP Mode Function and Operation Procedures
chap.7
¡ Operation procedure
1.
Enter
“
002
”
by the
NUMERIC
keys and then press the
(PRINT)
key.
a
To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
Call the HELP mode
“
H-002
”
.
5.
Press the (STOP) key.
The HELP mode selection display will reappear.
Return to the HELP mode.
Touch Panel Calibration
Calibrating the coordinates and checking operation of the touch panel.
3.
1. Touch the center point of the circle on the panel upper left.
2. The circle moves to the lower right. Touch the center point
again. (Calibration completed)
3. Press the key to store calibration.
Touch panel calibration
2.
For
“
Calibration
”
, press the
(MASTER MAKING)
key. Go to step
3
.
For
“
Check
”
, press the
(PROPERTY)
key. Go to step
4
.
Touch panel calibration/check
4.
1. When pressing the PROPERTY key in step
2
, the cross cursor
appears on the panel.
2. Check that the cross cursor follows the touch pen movement.
Touch panel check
¡
Press the (STOP) key to cancel calibration.
NOTE :
To Next Page
Loading...
Need help?
General
