Thread cutter
80 Service Instructions 1767 - 00.0 - 12/2016
3. Swivel the thread-pulling knife (6) forward until the circle mark is exactly
next to the tip of the counter blade (5).
4. Set the handwheel position to 60°.
5. Push the control cam (3) to the left up against the clamping ring (2).
6. Turn the control cam (3) such that the roller (1) runs up at the contour
of the control cam (3) and the widest extent of the control cam is at
handwheel position 60° at the highest point.
7. Tighten the threaded pins (4).
8. Check setting:
• Insert the thread into the thread-pulling knife (6) and slowly turn the
handwheel.
• Check the handwheel position at which the thread is cut.
• If necessary, repeat setting steps 1 – 7 until the cut takes place
at 60°.
To Next Page
Loading...
Need help?
General
