Winder
74 Service Instructions 1767 - 00.0 - 12/2016
15.3 Setting the hook thread guide
The position of the hook thread guide determines how the thread is wound
onto the winder.
Proper setting
The thread is wound on evenly over the entire width of the bobbin.
Fig. 59: Setting the hook thread guide
To set the hook thread guide:
1. Loosen the screw (1).
2. Turn the hook thread guide (2):
• To the front: The thread will be wound on further to the front
• To the rear: The thread will be wound on further to the rear
(1) - Screw (2) - Hook thread guide
To Next Page
Loading...
Need help?
General
