DURKOPP ADLER 1767 - Page 4

Table of Contents
2 Operating Instructions 1767 - 00.0 - 12/2016
5.1.1 Display.................................................................................................49
5.1.2 Buttons ................................................................................................51
5.1.3 Using button groups ............................................................................55
5.2 Thread button group functions ............................................................56
5.2.1 Setting the start bartack ......................................................................56
5.2.2 Setting the multiple start bartack.........................................................57
5.2.3 Using the multiple start bartack as the darning program.....................58
5.2.4 Setting the end bartack .......................................................................59
5.2.5 Setting the multiple end bartack..........................................................60
5.2.6 Activating the thread cutter..................................................................60
5.2.7 Activating the thread clamp.................................................................61
5.2.8 Setting the needle position after sewing stop......................................61
5.2.9 Activating sewing foot lift after thread cutter........................................61
5.2.10 Activating sewing foot lift after sewing stop.........................................62
5.2.11 Activating soft start..............................................................................62
5.2.12 Reducing speed ..................................................................................62
5.3 Programming button group functions ..................................................63
5.3.1 Setting the bobbin piece counter.........................................................64
5.3.2 Activating the bobbin stitch counter.....................................................66
6 Maintenance.......................................................................................67
6.1 Cleaning ..............................................................................................68
6.1.1 Areas requiring special cleaning .........................................................69
6.1.2 Cleaning the motor fan mesh ..............................................................70
6.2 Lubricating...........................................................................................71
6.3 Servicing the pneumatic system..........................................................73
6.3.1 Setting the operating pressure ............................................................73
6.3.2 Draining the water condensation.........................................................75
6.3.3 Cleaning the filter element...................................................................76
6.4 Parts list...............................................................................................77
7 Setup ..................................................................................................79
7.1 Checking the scope of delivery ...........................................................79
7.2 Removing the transport locks..............................................................79
7.3 Assembling the stand..........................................................................80
7.4 Tabletop ..............................................................................................81
7.4.1 Completing the tabletop ......................................................................81
7.4.2 Assembling the tabletop to the stand ..................................................82
7.5 Setting the working height...................................................................83
7.6 Assembling the pedal and setpoint device..........................................84
7.7 Inserting the machine head.................................................................85
7.8 Assembling the control panel ..............................................................86
7.9 Assembling the oil extraction line........................................................89
7.10 Electrical connection ...........................................................................90
7.10.1 Assembling the control........................................................................90