DURKOPP ADLER 1767 - Setting the end bartack

Programming
Operating Instructions 1767 - 00.0 - 12/2016 57
Double bartack
To set the double bartack:
1. Press twice.
 Both LEDs illuminate.
2. Press the A+ button from the Programming button group
repeatedly until the required number of forward stitches is
reached.
3. Press the B+ button repeatedly until the required number of
backward stitches is reached.
You can begin sewing; press the pedal forward to pedal
position +1.
To deactivate the start bartack press .
5.2.2 Setting the multiple start bartack
Use the multiple start bartack to set the number of stitches as well
as the number of repetitions (sections with forward and backward
stitches).
To set the multiple start bartack:
1. Press.
 The LED flashes. If it illuminates, the multiple start bartack
has been activated as the darning program and has to be
deactivated ( p. 58).
2. Press the A+ button from the Programming button group
repeatedly until the required number of forward stitches is
reached.
3. Press the B+ button repeatedly until the required number of
backward stitches is reached.
4. Press the D+ button repeatedly until the required number of
repetitions is reached.
5. Confirm your selection with .