Setup
86 Operating Instructions 1767 - 00.0 - 12/2016
To insert the machine head:
1. Screw the upper hinge parts (2) to the machine head.
2. Insert the machine upper section from above at an angle
of 45°.
3. Insert the upper hinge parts (2) into the rubber inlays (1).
4. Fold the machine head down and insert it into the slot.
7.8 Assembling the control panel
Fig. 40: Assembling the control panel (1)
To assemble the control panel:
1. Unscrew the belt cover (2) and the arm cover (1).
2. Guide the plug and cable of the control panel through the slot
in the arm cover.
3. Tighten the control panel (4) on the control panel holder (3).
(1) - Arm cover
(2) - Belt cover
(3) - Control panel
(4) - Control panel holder
To Next Page
Loading...
