Setup
82 Operating Instructions 1767 - 00.0 - 12/2016
5. Screw the thread reel holder and the thread guide onto the
reel stand (6)
in such a way that they are exactly on top of each other.
6. Insert the machine head support (1) into the hole.
7. Insert the lower hinge parts into the slots (2) and tighten.
8. Insert the rubber corners into the corner protrusions.
7.4.2 Assembling the tabletop to the stand
Fig. 36: Assembling the tabletop to the stand
To assemble the tabletop to the stand:
1. Place the tabletop on the head sections of the inner bars.
2. Tighten the tabletop at the screw holes (1).
(1) - Screw holes and screws
To Next Page
Loading...
