Programming
Operating Instructions 1767 - 00.0 - 12/2016 63
3. Press the D+ button.
The reduced speed increased by one-tenth.
You can also reduce the speed:
1. Press the C- button for one-on-hundredth and D- for
one-tenth.
5.3 Programming button group functions
Using the Programming button group you can set:
• Bobbin stitch counter
• Remaining thread monitor (if present)
• Piece counter
• Needle cooling (if present)
• Light barrier (if present)
Buttons and use
Important
If you press you can no longer sew.
Button Use
• Start parameter mode
• Select or save parameters
• Exit parameter mode and do not save
parameters
Plus button • Increase parameter
Minus button • Decrease parameter
To Next Page
Loading...
