DURKOPP ADLER 1767 - Activating the thread clamp; Setting the needle position after sewing stop; Activating sewing foot lift after thread cutter

Programming
Operating Instructions 1767 - 00.0 - 12/2016 59
5.2.4 Setting the end bartack
The end bartack secures the seam at the seam end. If a seam
consists of backward stitches only, one speaks of single bartacks.
A seam of forward and backward stitches is called a double
bartack.
Single bartack
To set the single bartack:
1. Press.
 The upper left LED illuminates.
2. Press the C+ button from the Programming button group
repeatedly until the required number of forward stitches is
reached.
You can begin sewing; press the pedal forward to pedal position +1.
At the end of the seam, press the pedal back to pedal position -2.
Double bartack
To set the double bartack:
1. Press twice.
 Both LEDs illuminate.
2. Press the C+ button from the Programming button group
repeatedly until the required number of forward stitches is
reached.
3. Press the D+ button repeatedly until the required number of
backward stitches is reached.
You can begin sewing; press the pedal forward to pedal position +1.
At the end of the seam, press the pedal back to pedal position -2.
To deactivate the end bartack press .