Setup
Operating Instructions 1767 - 00.0 - 12/2016 83
7.5 Setting the working height
The working height is continuously adjustable between 750 and
900 mm (clearance between the floor and upper edge of the
tabletop).
Fig. 37: Setting the working height
WARNING
Risk of injury from moving parts!
The tabletop can sink under its own weight when
the screws on the stand bars are loosened.
Crushing possible.
Ensure that your hands are not jammed when
releasing the screws.
CAUTION
Risk of musculoskeletal damage from
incorrect setting!
The operator can sustain musculoskeletal
damage if failing to comply with the ergonomic
requirements.
Adjust the working height to the body height of the
person who will operate the machine.
(1) - Screws
To Next Page
Loading...
