Programming
66 Operating Instructions 1767 - 00.0 - 12/2016
5.3.2 Activating the bobbin stitch counter
To activate the bobbin stitch counter:
1. Press.
Parameter mode is started.
2. Press the B+ button of the Programming button group repeat-
edly until 06 appears on the display:
If parameter 00 does not appear:
Press the D+ button repeatedly until the parameter appears
on the display.
3. Press.
The LED of the button flashes. 0 appears on the
display.
4. Press the D+ button.
1 appears on the display.
5. Confirm your selection with .
The bobbin stitch counter is activated.
6. Exit parameter mode with .
To deactivate the bobbin stitch counter again, in category 06
change parameter 00 to 0.
To Next Page
Loading...
