DURKOPP ADLER 1767 - Maintenance

Programming
Operating Instructions 1767 - 00.0 - 12/2016 65
3. Press.
 The LED of the button flashes.
4. Use the D- or D+ button to set the reset value to 400.
5. Confirm your selection with .
6. Press the D+ button repeatedly until 04 appears on the
display:
Use parameter 04 to set the factor.
7. Press.
 The LED of the button flashes.
8. Use the D- or D+ button to set the factor to 20.
9. Confirm your selection with .
10. Exit parameter mode with .
 The bobbin stitch counter is at 8000.
In addition to A, there are 2 other bobbin stitch counters.
Use parameter 02 and 03, respectively, to set the reset value for
bobbin stitch counter B and C.
Reset the bobbin stitch counter with the button.