Programming
66 Service Instructions 878-M PREMIUM - 03.0 - 10/2019
17.3 Parameter selection (ParameterCall) submenu
The submenu is visible only if the ParameterView parameter is active
(ParameterView)( p. 83). The settings for a parameter can be changed
directly here.
To change the parameters:
1. Select the menu Service > ParameterCall (Service > Parameter
selection).
2. Press the OK button to confirm the selection.
A window appears where the parameter can be selected:
Fig. 56: ParameterCall (Parameter selection) submenu
3. Select the level of the desired parameter with the ▲/▼ buttons.
4. Use the
► button to move to the Cat category and select the desired
value with the
▲/▼ buttons or the number keys. The categories are
explained in the Parameter list 878-M PREMIUM.
5. Use the
► button to move to the Par parameter and select the desired-
value with the
▲/▼ buttons or the number keys. The parameters are
explained in the Parameter list 878-M PREMIUM.
6. Use the
► button to move to the fourth value on the far right. This value
may vary, depending on the parameter. It may be a mode or a window
with an action selection.
7. Enter the parameter value and confirm by pressing OK.
Abbreviation Meaning
O Operator
T Technician
To Next Page
Loading...
