DURKOPP ADLER 878-M PREMIUM Service Instructions

Programming
Service Instructions 878-M PREMIUM - 03.0 - 10/2019 69
17.4.5 Setting the Fullness degrees (Fullness) parameter
Fullness degrees range:
0 – 16.
To set the Fullness degrees parameter:
1. Select the Fullness parameter.
2. Press the OK button to confirm the selection.
3. Enter the desired value (
0 – 16).
4. Press the OK button to confirm the value.
17.4.6 Setting the Start bartack (StartTack) parameter
Setting whether the start bartack is automatically activated in a new
program.
17.4.7 Setting the End bartack (EndTack) parameter
Setting whether the end bartack is automatically activated in a new
program.
17.4.8 Setting the Thread Trim (ThreadTrim) parameter
Setting whether the thread trim is automatically activated in a new program
or not.
Menu item Setting option
On The start bartack is activated automatically. The values for the start
bartack are taken from Manual mode.
Off The start bartack is not activated.
Menu item Setting option
On The end bartack is activated automatically. The values for the end
bartack are taken from Manual mode.
Off The end bartack is not activated.
Menu item Setting option
On The thread trim is activated automatically at the end of a seam section
and at the end of the sewing program.
Off The thread trim is not activated.

DURKOPP ADLER 878-M PREMIUM Specifications

General

Brand	DURKOPP ADLER
Model	878-M PREMIUM
Category	Sewing Machine
Language	English