Programming
Service Instructions 878-M PREMIUM - 03.0 - 10/2019 103
17.13 Perform software update
When a new software version is available, this can be downloaded from
www.duerkopp-adler.com and loaded into the control via a USB key.
All settings on the machine are retained.
To load software via a USB key:
1. Switch off the machine with the main switch.
2. Plug the USB key into the socket (1) on the control (2).
Fig. 76: Perform software update
3. Switch on the machine with the main switch.
The machine automatically starts the software transfer. During the
transfer, the display only shows the firmware version (3) of the control
panel on the left.
Fig. 77: Perform software update
As soon as the software update is finished, the display will also show
the software version (4) of the machine on the right.
(1) - Connection (2) - Control
(3) - Firmware version
To Next Page
Loading...
