Programming
Service Instructions 878-M PREMIUM - 03.0 - 10/2019 97
3. Select the desired option – see the table – with the ▲/▼ buttons.
4. Press the OK button to confirm the selection.
The reset is carried out without any further query and without a
confirmation message.
Options for resetting the data
17.11 Data transfer (DataTransfer) submenu
Use this submenu to transfer data between the machine – or more precisely
the control – and a USB key. Various options are available for the data
transfer, which are explained in the subchapters.
The menu is divided into the following submenus:
Important
It is only permitted to use USB keys bought from Dürkopp Adler.
17.11.1 Setting the All data (AllData) parameter
All data – i.e. parameter settings, programs and calibration values – are
transfered to the USB key or the control.
To transfer all data:
1. Plug the USB key into the socket (1) on the control (2).
Menu item Setting options
Reset data All parameters are reset to the factory settings; this does not
apply to the programs and the calibration values.
Reset programs All created programs are erased.
Reset Calibr. All calibration values are reset to the factory settings.
Reset all All parameters, programs and calibration values are reset to the
factory settings.
Parameter Explanation Reference
All Data All data p. 97
Only Data Only data p. 99
Programs Programs p. 100
To Next Page
Loading...
Need help?
General
