Programming
70 Service Instructions 878-M PREMIUM - 03.0 - 10/2019
17.4.9 Setting the Daily piece counter (DailyPieces) parameter
The daily pieces counter can count upward or downward. It is also possible
to enter the value to be selected when the counter is reset.
17.5 Machine configuration (MachineConfig) submenu
Settings on the machine that apply to all programs can be determined
here. The parameters are explained in more detail in the subchapters.
The menu is divided into the following submenus:
Menu item Setting option
CntMode Off– the counter is off
Up – the daily pieces counter counts upward
Down – the daily pieces counter counts downward
Reset Enter the value to which the daily pieces counter should return when it
is reset (value range -999 – 999).
Parameter Explanation Reference
Thread Trim Thread Trim p. 71
Thread Clamp Thread clamp p. 72
Speed Speed p. 74
Stop Positions Stop positions p. 74
Foot Sewing foot p. 75
Thr.Tens. Needle thread tension p. 75
Stitch Length Stitch length p. 76
Bobbin Bobbin p. 77
Holding Force Motor holding force p. 77
Pedal Pedal p. 78
NeedleCooling Needle cooling p. 78
Center Guide Seam center guide p. 79
EdgeGuide Edge Guide p. 79
FabricThickness Material thickness detection p. 80
Speed Corr Correcting effects of high speed p. 80
LightBarrier Light barrier p. 81
Mode Seg.Size Segment length p. 81
Threading Threading mode p. 82
To Next Page
Loading...
Need help?
General
