Programming
Service Instructions 878-M PREMIUM - 03.0 - 10/2019 73
Option Mode of thread clamp
0 – at seam start only
1 – at seam start and during reversal
2 – at seam start and during sewing foot lift
3 – at seam start and during reversal and sewing foot lift
PWM Config Pulse width modulation
Power supply to the magnet for the thread clamp.
t1 [ms]
Activation duration of the thread trim in time period t1.
(Value range 000 – 1000 [ms])
DtyC. t1 [%]
Duty cycle in time period t1
(Value range 000 – 100 [%])
t2 [s]
Activation duration of the thread trim in time period t2.
(Value range 000 – 600 [s])
DtyC. t2 [%]
Duty cycle in time period t2
(Value range 000 – 100 [%])
Neat Seam
Beginning
Neat seam beginning
(Value range On/Off)
Trim Delay
Delay after thread trimming when NSB is activated.
(Value range 0000 – 1000 [ms])
Knife
Value for the first position of the knife after seam start.
(Value range 000 – 359)
Knife Clamp
Value for switching off the knife clamp.
(Value range 000 – 359)
Exhaust
Exhaust removal of the trimmed residual thread.
On° – Position for the start of exhaust removal
(Value range 000 – 359)
Off[ms] – Duration of the exhaust removal
(Value range 00000 – 99999 [ms])
Menu item Setting options
To Next Page
Loading...
