To Next Page
F
fuentesericAug 6, 2025
How to start Dynapac D.ONE with jump leads?
- DDavid ChapmanAug 6, 2025
To start the Dynapac Construction Equipment engine with jump leads, first open the rear protective hood and switch on the main battery switch. Connect the plus pole of the external battery to the plus pole of the starter battery using the first jump lead. Next, connect the second jump lead to the minus pole of the energizing external battery and then to the minus pole of the starter battery. After starting, disconnect the minus poles first and the plus poles after. Finally, close the rear protective hood.
General
