7.5 After transport
Use only stable loading ramps of sufficient load bearing capacity.
Loading ramps and transport vehicle must be free of grease, oil,
snow and ice.
The ramp inclination must be less than the gradeability of the
machine.
Make sure that any persons keep a safety distance of at least 2
metres while the machine is driven onto or down from the transport
vehicle. The instructing person should not be inside the travel
range of the machine.
1.
Loosen the articulation lock
Ä
Chapter 8.2.2.2 „Disengaging
the articulation lock“ on page 104.
2. Switch the toggle switch for travel speed ranges to the “rear”
position.
3.
DANGER!
Danger to life caused by the machine slip-
ping or turning over!
– Make sure that no persons are in the
danger zone.
Drive the machine carefully off the transport vehicle.
Fig. 123
Loading / transporting the machine – After transport
D.ONE
100
To Next Page
Loading...
