Dynapac D.ONE - Start-Up Procedure; Preparing the Remote Control

6.2 Start-up procedure
6.2.1 Preparing the remote control
1. Open the flap (1) and take the remote control (2) out of the
holding fixture (3).
2. Strap on the remote control and hold in front of your body.
3. During cable operation, remove the safety cap (1) and con-
nect the cable (2) to the remote control.
4. Use the toggle switch to select the required operating mode.
3
2
1
B-720-0019
Fig. 64
B-720-0012
ca. 1 m
approx. 1.1 yd
Fig. 65
2
1
B-720-0029
Fig. 66
B-720-0013
Fig. 67
Operation – Start-up procedure
D.ONE
74