3.7 Operation with radio remote control
The machine must only be operated within the operator’s field of
vision.
In case of radio interferences, watch the fault code display and
switch to cable remote control, if necessary.
Shut down defective radio remote controls immediately. Actuate
the emergency stop. Disconnect the connecting cable on the
receiver from the machine socket.
The radio remote control must only be repaired by the manufac-
turer or specialists authorised by the manufacturer.
The radio remote control must never be left unattended.
If several machines are in operation at the same time, the system
numbers on the radio remote control and receiver must be com-
pared before start-up to ensure another machine within range is
not accidentally started up.
Concerning your safety – Operation with radio remote control
D.ONE
34
To Next Page
Loading...
