Dynapac D.ONE - Switching off the Machine Manually

10.2 Switching off the machine manually
If the remote control malfunctions, the engine can
be switched off manually.
1. If possible, move the machine onto level, firm ground.
2. Set the travel lever to “middle” position to stop the machine.
NOTICE!
Danger of engine damage!
– Do not shut down the engine all of a sudden
from full load speed, but let it idle for about two
minutes.
3. Turn the ignition key to position “0” and pull it out.
4. Open the front protective hood.
5. Move the lever on the engine and hold.
ð
The engine is shut down.
6. Close the front protective hood again.
7. Open the flap.
AUTOMATIC
MAX
MIN
B-720-0024
Fig. 195
B-720-0028
Fig. 196
B-720-0114
Fig. 197
Troubleshooting – Switching off the machine manually
D.ONE
151