Dynapac D.ONE - Checking the Remote Control

5. Close the flap.
6.2.2 Checking the remote control
Protective equipment:
n
Working clothes
n
Safety shoes
n
Protective gloves
n
Hearing protection
Prerequisites:
n Main battery switch is switched on
n Emergency stop switch is unlocked
1.
Prepare the remote control
Ä Chapter 6.2.1 „Preparing the
remote control“ on page 74.
2. If several machines are used at the same time, compare the
system numbers on the remote control and receiver.
ð
The system numbers on both devices must match.
3. Exchange the remote control, if necessary.
4. Switch the toggle switch for engine speed to "MIN” position.
B-720-0071
Fig. 68
Preparations
MAX
MIN
B-720-0074
Fig. 69
Operation – Start-up procedure
D.ONE
75