7.4 Loading by crane
Loads must only be attached and hoisted by an expert / capable
person.
Do not use damaged or in any other way impaired lashing points.
Use only lifting gear and lifting tackle with sufficient load bearing
capacity for the weight to be loaded. Minimum load bearing
capacity of lifting gear: see max. operating weight
Ä
Chapter 2
„Technical data“ on page 11.
Always use appropriate lifting and lashing means on the lifting and
lashing points.
Use lifting and lashing gear only in the prescribed direction of load
application.
Lifting tackle must not be damaged by machine components.
When lifting the machine avoid uncontrolled movements of the
load. If necessary hold the load with guide ropes.
1. Switch off the engine and remove the ignition key.
2.
Engage the articulation lock
Ä
Chapter 8.2.2.1 „Engaging the
articulation lock“ on page 103.
3. Attach the lifting tackle to the central lifting point.
4.
DANGER!
Danger to life caused by suspended
loads!
– Do not step or stand under suspended
loads.
Lift the machine carefully and set down again at the intended
location.
Fig. 122
Loading / transporting the machine – Loading by crane
D.ONE
99
To Next Page
Loading...
