3.5 Loading/transporting the machine
Use only stable loading ramps of sufficient load bearing capacity.
Loading ramps and transport vehicle must be free of grease, oil,
snow and ice.
The ramp inclination must be less than the gradeability of the
machine.
Make sure that persons are not endangered by the machine tipping
or sliding.
Secure the machine with the articulation lock after driving it onto
the transport vehicle or prior to lifting.
Do not use lifting points that are damaged or impaired in any way.
Always use appropriate lifting tackle at the lifting points.
Use lifting tackle only in the specified loading direction.
Lifting tackle must not be damaged by machine parts.
Secure the machine on the transport vehicle against rolling, slip-
ping and turning over.
Loads may only be attached and hoisted by an expert/qualified
person.
Only use lifting and lashing tackle with sufficient load bearing
capacity for the weight to be loaded.
Fasten the lifting gear only at the specified lifting points.
Danger to the life of persons if they step or stand under a sus-
pended load.
When lifting the machine, make sure the load does not move in an
uncontrolled way. If necessary, hold the load steady with guide
ropes.
After the transport loosen the articulation lock again, as otherwise
the machine would not be steerable.
Concerning your safety – Loading/transporting the machine
D.ONE
31
To Next Page
Loading...
