10.6 Remote control faults (cable operation)
Fault Possible cause Remedy
Engine stops for no
reason
Emergency stop switch actuated or
defective
Pull out the emergency stop switch
Have examined by a specialist; replace if
necessary
Fuse F54, F67 or F103 triggered Check the fuses; replace if necessary
Have examined by a specialist
Operating mode toggle switch defective Have examined by a specialist; replace if
necessary
Relay K11 defective Have examined by a specialist; replace if
necessary
Cable defective Check cable for tight fit
Have examined by a specialist; replace if
necessary
Remote control defective Have examined by a specialist; replace if
necessary
Cross-slope sensor defective Check the cross-slope sensor signal,
input code 1405
Have examined by a specialist; replace if
necessary
Control defective Have examined by a specialist; replace if
necessary
Ignition key in posi-
tion "I", display
module operative,
but engine cannot
be started
The travel lever or steering lever is not in
neutral position
Disengage the travel lever or steering
lever and move to neutral position
Check the travel lever signal, input code
2500
Check the steering lever signal, input
code 2501
Fuse F119 triggered Check the fuses; replace if necessary
Have examined by a specialist; replace if
necessary
Battery not charged or defective Check the battery charge; recharge if
necessary
Replace defective battery
Cross-slope sensor defective Check the cross-slope sensor signal,
input code 1405
Have examined by a specialist; replace if
necessary
Relay K39 defective Check the relay control signal, input code
5070
Have examined by a specialist; replace if
necessary
Troubleshooting – Remote control faults (cable operation)
D.ONE
159
To Next Page
Loading...
