3. Turn the ignition key to position “I”.
ð
The preheating control light on the display module lights
up.
The machine type code is displayed on the display
module screen for approx. 3 s.
The horn signal sounds on the machine as soon as the
machine is ready for operation.
If the horn does not sound, the machine
is faulty.
Two buzzer signals sound on the remote control as soon
as the remote control is ready for operation.
If the buzzer does not sound, there is a
fault in the remote control or the battery
is empty (for radio remote control).
4. With cold outside temperatures, wait up to 10 seconds before
starting (pre-warming).
5. Press the start button.
ð
The starter cranks the engine.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while
before starting work. Do not operate
the engine immediately under full
load.
Fig. 85
Fig. 86
Fig. 87
Operation – Start-up procedure
D.ONE
82
To Next Page
Loading...
