Chapter 11: Reference Section 177
Z-PLANE FILTER DESCRIPTIONS
F014 Flng>Flng3b
Morph: Sweeps from flange 1 to 2
Freq. Tracking: Provides key tracking to enhance flanging
Transform 2: Increases depth of flange
Comments: A gentle sweeper.
F015: Flng>Flng4
Morph: Sweeps flange
Freq. Tracking: Provides key tracking to enhance flanging.
Transform 2: Reduces depth of flange effect with Morph offset,
otherwise, increases flange depth.
F016 Flng>Flng5
Morph: Sweeps from flange 1 to 2
Freq. Tracking: Provides key tracking to enhance flanging.
Transform 2: Increases depth of flange, more bell-like.
Comments: Morphing sweeps gently, but Transform 2 adds more
depth and introduces a bell-like quality to the flange.
F017 Flng>Flng6
Morph: Sweeps from flange 1 to 2.
Freq. Tracking: Provides key tracking to fix partials.
Transform 2: Provides more brightness and flange.
F018 Flng>FlngT
Morph: Sweeps between flat and flange.
Freq. Tracking: Provides key tracking to fix partials.
Transform 2: Provides more brightness and flange.
Comments: A gentle-touch flanger. Low Transform 2 gives a soft
chorus on morphing. Higher Transform 2 gives exaggerated depth.
F019 Flng>FlngC
Morph: Sweeps from open to closed response with all other axes at
0.
Freq. Tracking: Controls brightness.
Transform 2: Adds extra flange.
F020 CO>FlngT
Morph: Sweeps from a reveal (almost flat) point to low pass peaks
Freq. Tracking: Raises frequency of peaks.
Transform 2: Increases depth of flange.
To Next Page
Loading...
