E-Mu MORPHEUS - Page 241

Chapter 11: Reference Section 231
MIDI SPECIFICATION
••• The Parameters labeled
with (L) are the primary
layer. The secondary layer
parameters bigin at number
243.
Offset Name Range
233 (L) Double+Detune 0-15, 0 = Off
234 (L) Sound Reverse 0-1, Off, On
235 (L) Nontranspose 0-1, Off, On
236 (L) Filt Type See FILTER TYPES
237 (L) Filt Reverse 0-1, Off, On
238 (L) Filt Level 0-255
239 (L) Filt Morph 0-255
240 (L) Filt FrqTrk 0-255
241 (L) Filt Trans2 0-255
242 (L) Unused 0
(L) = Layer ... 2 layers (35 parms each)
cs Checksum
F7 End of SysEx Status
• Hyperpreset Request
Request Hyper uses index values (not the same as program numbers).
Request for RAM Card presets will be ignored if card is not present.
Hyperpreset numbers are: 0-127 RAM, 128-255 CARD. Values 0x0400
+ bank # represent request for banks. (Banks are blocks of 128 Hypers.)
F0 SysEx Status Byte
18 E-mu Mfg ID
0C Morpheus Product ID
dd Device ID 0-15
44 Command ID
ll Hyperpreset Number ls byte
mm Hyperpreset Number ms byte
F7 End of SysEx Status
• Hyperpreset Data
Version 0x01 format is as follows:
F0 SysEx Status Byte
18 E-mu Mfg. ID
0C Morpheus Product ID
dd Device ID 0-15
45 Command ID
vv Data Version
ll ls Byte Hyperpreset Number
mm ms Byte Hyperpreset Number