Eaton MVX9000 - Page 154

MVX9000 Parameter Listing
B-16 MVX9000 User Manual
Parameter Tables
Table B-8: 90 — COMMUNICATION PARAMETERS (Continued)
Modbus Groups Page # Description Range Default
User
Settings
0708H 90.09 5-65 Status monitor for
error code
19: Auto Adjust Accel/Decel
Failure (cFA)
NA
20: Software Protection Code
(codE)
0709H 90.10 5-66 Status monitor for
AC drive
(Bit 0-1)
00 Stop NA
01: Decelerate upon stop
command
10: Drive is standing by
11: Run
(Bit 2) 1: JOG
(Bit 3-4) 00: FWD
01: REV to FWD
10: FWD to REV
11: REV
(Bit 5-7) Reserved
(Bit 8) 1: Source of frequency by
communication
(Bit 9) 1: Source of frequency by
Analog Input
(Bit 10) 1: Source of operation by
communication
(Bit 11) 1: Parameters have been
locked
(Bit 12-15) Reserved
070AH 90.11 5-66 Status of
Communication
frequency
0.0 to 400.0 Hz NA
070BH 90.12 5-66 Status of output
frequency
0.0 to 400.0 Hz NA
070CH 90.13 5-66 Status of output
current
0.0 to Max Amps NA
070DH 90.14 5-66 Status of user
defined display
(High word)
00 to 65535 NA
070EH 90.15 5-66 Status of user
defined display
(Low word)
0.00 to 65535 NA
070FH 90.16 5-66 Status of output
voltage
0.0 to Max V AC NA
0710H 90.17 5-66 Status of drive
temperature
0.0 to Max degree C NA
0711H 90.18 5-66 Status of DC bus
voltage
0.0 to Max V DC NA
0712H 90.19 5-66 Status of multi-step 0 to Max step NA
0713H 90.20 5-66 Status of PLC time 00 to 65535 NA
0714H 90.21 5-66 Status of counter 00 to 65535 NA
0715H 90.22 5-66 Status of feedback
signal
0.0 to 400.0 Hz NA
0716H 90.23 5-66 Status of PID
Setpoint
0.0 to 400.0 Hz NA