User Authentication
3-53
3
CLI – Use the snmp-server view command to configure a new view. This example
view includes the MIB-2 interfaces table, and the wildcard mask selects all index
entries.
User Authentication
You can restrict management access to this switch and provide secure network
access using the following options:
• User Accounts – Manually configure management access rights for users.
• Authentication Settings – Use remote authentication to configure access rights.
• HTTPS Settings – Provide a secure web connection.
• SSH Settings – Provide a secure shell (for secure Telnet access).
• Port Security – Configure secure addresses for individual ports.
• 802.1X – Use IEEE 802.1X port authentication to control access to specific ports.
• IP Filter – Filters management access to the web, SNMP or Telnet interface.
Configuring User Accounts
The guest only has read access for most configuration parameters. However, the
administrator has write access for all parameters governing the onboard agent. You
should therefore assign a new administrator password as soon as possible, and
store it in a safe place.
The default guest name is “guest” with the password “guest.” The default
administrator name is “admin” with the password “admin.”
Console(config)#snmp-server view ifEntry.a 1.3.6.1.2.1.2.2.1.1.*
included 4-115
Console(config)#exit
Console#show snmp view 4-116
View Name: ifEntry.a
Subtree OID: 1.3.6.1.2.1.2.2.1.1.*
View Type: included
Storage Type: nonvolatile
Row Status: active
View Name: readaccess
Subtree OID: 1.3.6.1.2
View Type: included
Storage Type: nonvolatile
Row Status: active
View Name: defaultview
Subtree OID: 1
View Type: included
Storage Type: nonvolatile
Row Status: active
Console#
To Next Page
Loading...
Need help?
General
